Cutting Plotter/Computer Communication Problems - MUTOH ValueCut II VC2-600 User Manual

ValueCut USER MANUAL

7.3 Cutting Plotter/Computer Communication Problems

The messages showed below present problems in relation to cutting plotter / computer communication.
Try the communication between
your cutting plotter and computer.
If it still does not work, have your
cutting plotter serviced.
Note:
The computer also needs to set up compatible communication parameters to the cutting plotter set up.
VC2E-A-00
Is the connection cable connected to
the cutting plotter and computer
properly?
Yes
Has the interface setting been
done correctly?
Yes
If your cutting plotter cannot recognize the
HP-GL/2 or HP-GL commands, please check the
HP-GL/2 or HP-GL commands applied to your
cutting plotter are used properly.
Refer to Chapter 2 -
Connecting your cutting
plotter.
No
Refer to the "MISC" key in Chapter
3 - Description of Operation for the
port setup.
73
Trouble Shooting
No