GLP SCAN OPERATOR FX II User Manual page 29

Hint:
By pressing the "releases" key you can set all channels back to the value 0. Also
all channels will be switched to "off" again, so that you can begin to program a
new overlay from ground up.
7. You can set the desired values wit the faders. You might also set the values of
the channels, which will not be overwritten (status "off").
However, these will not be overwritten later, if the overlay scene is called up.
8. If necessary, press the PAGE key, in order to be able to change the further 8
DMX of channels (9-16).
9. Repeat the steps 3 to 6, in order to configure further Fixtures.
10. If the desired overlay scene is programmed, then store it in the Scan Operator,
by pressing the RECORD key once
11. Afterward press the appropriate overlay scene key, which you would like to
store it to. The procedure corresponds to the sequence, as if you wanted to store
a normal scene on overlay a key.
For confirmation you receive the message "Scene Saved".
Hint:
If you should provide several overlay scenes one after the other, then you would
eventually like to set, after providing a overlay scene, all channels on "OFF" again,
in order to provide the next overlay scene from a firm starting point.
You can reach this very simply, by pressing "release" key. All channels are set on
"off" again and overwritten with the value "0".
To leave PROGRAM mode, press PROGRAM key for 3 seconds.
29/57