Creating An Effect - GLP SCAN OPERATOR FX II User Manual

the effect "Wild" and select any size, and a slow speed. All 12 fixtures will implement
synchronously the "Wild" movement now.
After pressing the Randomize key the starting angles for pan and Tilt become
randomized. This leads to it that all fixtures move, however each lamp drives another
way. If you combine this with a small point Gobo now, then you produced a "searchlight"
effect.

4.11.4 Creating an effect

In order to create an effect, you proceed as follows:
1. Activate PROGRAM mode (PROGRAM key)
2. Start the effect by pressing the "FX editor" key. Now the 12 keys of the
effects section should light up
3. Select desired lamp with their Fixture key. Several Fixtures can be
selected at the same time.
4. Now select the desired effect by pressing the appropriate effect key.
5. With the "FX Speed" and "FX Size" Faders you can change the size and
speed of an effect for the selected fixtures. Size and speed can be selected in
8 stages in each case.
6. With the keys "Offset+" and "Offset -" and/or. "Bank UP" and "Bank down"
you can increase and/or manually make a smaller starting angle ("offset") of
the selected lamps in 90° steps.
Alternatively the starting angle can be varied by means of "Create Wave" or
"Randomize" key (see above).
7. With the Faders you can still adjust DMX values while the effect editor is
activated. Pan and Tilt of values function thereby as center of the selected
effect.
8. If necessary you press the PAGE key, in order to be able to change the
further 8 DMX of channels (9-16).
9. Repeat the steps 3 to 8, in order to provide effects for further lamps.
10. You can delete an effect for the selected Fixtures at any time, by operating
33/57