Deleting Overlay Scenes; Using Overlay Scenes (Play Mode); Effect Generator - GLP SCAN OPERATOR FX II User Manual

4.10.2 Deleting Overlay Scenes

For the deletion of an overlay scene you proceed as follows:
1. Activate PROGRAM mode (PROGRAM key)
2. Select bank 31 and/or the position, where the bank 31 would be. The display
will show "overlay".
3. Keep the DELETE key pressed and simultaneously press the key of the
overlay scene, which you would like to delete.
For confirmation you will receive the message "Deleted".
4. To leave PROGRAM mode, press the PROGRAM key for 3 seconds

4.10.3 Using Overlay Scenes (Play mode)

In order to call up an overlay scene in Play mode, these must have been provided
before in Program mode. Now you can load one of the 6 overlay scenes, in order to
change the current program. You can only activate one overlay scene at a time.
Renewed pressing deactivates the overlay scene again.
4.11

Effect Generator

The Effect Generator allows you to use 12 predefined movement patterns for Pan/Tilt
and store them together with normal DMX values into a scene. The different movement
patterns can be selected and adapted in size, speed and starting angle. Effects can be
programmed independently for each fixture.
The output of the effects value for each fixture is added to the channels that are defined
as Pan and Tilt in the Setup Menu (Default is channel 1/2). Thus the produced values of
an effect are added to the Pan/Tilt values stored in the scene. The base values that are
stored inside the scene can be regarded as the center position of the effect.
30/57