Programming Chasers; Inserting A Step Into A Chaser - GLP SCAN OPERATOR FX II User Manual

4.7 Programming Chasers

A Chaser is a program, which calls at maximum of 250 scenes successively. You must
have programmed the scenes, from which you "build up" the Chaser, before.
Should you change scenes later, the program of the Chaser changes as well. Should a
scene in which a chaser is used, be deleted afterward, then the chaser will not load the
scene, since it is empty.

4.7.1 Inserting a Step into a Chaser

With this function you can insert a scene, which is loaded, straight into a Chaser (behind
the current step of the Chasers).
1. Activate PROGRAM mode (PROGRAM Key).
2. Press the Chaser key that you would like to program a Chaser to. Only one
Chaser can be programmed at a time.
Hint:
If you switch on a Chaser that is already containing steps in the Program
mode, then this jumps automatically to the last step of its programming.
Inserting takes place at the end of the Chasers.
3. Load one of the scenes that you stored to one of the banks before, by
pressing the appropriate scene key.
4. Press the RECORD key.
5. As confirmation of inserting the display shows the message "Scene
Inserted".
6. Repeat the steps 3 and 4 to arrange the desired program. You can store a
maximum of 250 steps in a Chaser.
7. If a Chaser has reached the maximum number of steps, the display shows
the message "Chaser Full".
20/57