Configuring The Cl1; Default Control Settings; Control Options - GLP Creative Light 1 User Manual

6. Configuring the CL1

The menus in the control panel on the front of the CL1 give a range of options for
configuring the fixture. See 'Control menus' on page 36 for an overview of the
menus.
In the CL1+, a range of configuration options is also available via DMX on the Control
/ Settings DMX channel. See the DMX Channel Index section at the back of this
manual for details.
The configuration options available are described in this chapter.

Default control settings

By default, the CL1 and CL1+ are set up as follows:
• The CL1 is set to SIGNAL SOURCE: iQ.Mesh and NO-SIGNAL: MANUAL CONTROL.
This means the fixture automatically switches to manual / IR remote control as
long no valid iQ.Mesh Signal is being received or the fixture is not linked to the
Creative Light smartphone app.
• The CL1+ is set to SIGNAL SOURCE: CRMX and NO-SIGNAL: MANUAL CONTROL.
This means the fixture automatically switches to manual / IR remote control as
long no valid CRMX Signal is being received or the fixture is not linked to CRMX.
You can change these default settings in the fixture's control menus under SIGNAL
SETTINGS → SIGNAL SOURCE and FIXTURE SETTINGS → NO-SIGNAL BEHAVIOR. See the
following sections for details.

Control options

To select a control method for the CL1:
Enter the control menus and use the UP and DOWN buttons to scroll to SIGNAL
SETTINGS. Press ENTER.
Scroll to SIGNAL SOURCE. Press ENTER.
Scroll to one of the following options and press ENTER to select:
• CRMX (CL1+ only)
If you select CRMX, the letters CRMX appear in the bottom right-hand corner
of The CL1+ display. You can now link the fixture to a CRMX transmitter. See
'Linking to a CRMX Transmitter (CL1+ only)' on page 19 for instructions. Once
the fixture is linked you can control the CL1+ by DMX.
Note: Don´t forget to choose a DMX Control Mode in the CONTROL MODE
menu and give the CL1+ a suitable DMX Address in the DMX ADDRESS menu.
• iQ.Mesh
If you select IQ.MESH, the name iQ.Mesh appears in the bottom right-hand
corner of the CL1 display. You can now link the CL1 to GLP's iQ.Mesh network
and Creative Light smartphone app. See 'Creative Light app control' on page
24 for instructions.
CL1 / CL1+ User Manual
16
www.glp.de