Autostart Function; Activating The Autostart Function; Configuring Autostart Desklock - GLP SCAN OPERATOR FX II User Manual

4.16

Autostart function

The Scan Operator FX II offers an Autostart function, which repairs the stored playback
condition by switching the set on and off. In addition the possibility exists that when
switching the set on, the Desklock is activated automatically.

4.16.1 Activating the Autostart Function

In order to activate the Autostart mode, you proceed as follows:
1. Activate Setup mode (SETUP key)
2. Now select "Autostart" in the menu of Setup mode (shortened by
"Autostrt").
3. Now use the Pan Encoder, in order to activate and/or deactivate the
Autostart function.
Important:
The changes are not automatically durably stored but they are directly active.
Therefore it is necessary that you confirm the changes for durable storing
once with the RECORD or the SETUP key.
4. Press the SETUP key for 3 seconds, to leave the Setup mode again.

4.16.2 Configuring Autostart Desklock

In order to activate the Desklock mode automatically when switching on of the
equipment on, you proceed as follows:
1. Activate Setup mode (SETUP key).
2. Now select "Autostart" in the menu of Setup mode (shortened by
"Autostrt")
3. Now use the Tilt Encoder, in order to activate and/or deactivate the
Autostart function.
Important:
The changes are not automatically durably stored but they are directly active.
41/57