Reading The Lcd Display; Switching To Program Mode - GLP SCAN OPERATOR FX II User Manual

4.4 Reading the LCD Display

The LCD display consists of 2 lines of each 8 signs. The display is intensively used to
show the current condition. In a normal condition it always shows the current mode in
the first line. In the line below you can find information to the belonging mode.
In Play Mode you have the current bank and the current scene shown in the second
line. If a chaser is activated, it will be shown at the end oft he first line.
In Program mode you can also see the current bank and scene in second line. Besides
that there is a extra „Overlay Bank" that should be marked with „Overlay".
In Setup Mode you can see the belonging menu point in second line, which you can
configure now. The following menu points can be chosen:
 "MIDI" to configure the MIDI channel and MIDI assignment
 "Invert" to reverse channels
 "Fadetime" to configure Fadetime channels
 "Tilt" to configure the Tilt Encoder wheel
 "Pan" to configure the Pan Encoder wheel
 „Autostart" to configure the Autostart options
In Easy Mode the second line is blank.
Besides that the display also shows a short confirmation or an error report. These
overwrite the current information of the display for a few seconds. Afterward the display
turns back to its normal condition. Examples fur such short reports are „Memory Reset",
„Scene Saved", „MIDI Set / Keyboard", „Fader XY / Value ABC" ...

4.5 Switching to Program Mode

After turning the unit on you are in PLAY Mode.
By pressing the Program key for 3 seconds you change to program mode. Here
scenes, effects and chasers can be created and the Blackout functions as well as
the Overlay scenes can be configured. After pressing the program key again for 3
seconds, you return to play mode.
15/57