Programming Scenes; Creating A New Scene - GLP SCAN OPERATOR FX II User Manual

4.6 Programming scenes

4.6.1 Creating a new Scene

A scene is an adjustment of all 192 DMX values of different DMX sets including a
possible Pan/Tilt effect for each fixture. Up to 240 scenes can be stored. The scenes
are subdivided in 30 banks with each 8 scenes.
1. Activate PROGRAM mode (PROGRAM key).
2. Select desired Fixtures with associated Fixture keys. Thereby several Fixtures
can be selected at the same time.
3. Adjust the desired DMX values (0 to 255) with the Fader.
4. If you need to change to channels 9-16 press the "Page" key. If you'd like to
edit channel 1-8, just press the "Page" key again.
Repeat the steps 2-4 until all DMX values correspond to your desires.
Hint:
By pressing the RELEASE key you can set all 192 channels back to the DMX
value "0" at any time and start altering the values again.
For storing continue with step 5:
5. If the current bank does not match the desired bank, then you might select the
desired bank using the BANK keys. 30 banks are available. You can store up to 8
Scenes in each bank.
If the desired scene is created, then you can store it in the Scan Operator by
pressing the RECORD key once.
6. Afterward press the scenes key, which you would like to store the scene to.
16/57