Inverting Channels; Configuring Inverted Channels - GLP SCAN OPERATOR FX II User Manual

4.13

Inverting channels

Each of the 192 channels can be inverted individually. Inverting takes place in the Setup
menu and is deleted likewise with the deletion of the entire memory.

4.13.1 Configuring Inverted Channels

To toggle the inversion of one or more channels you proceed as follows:
1. Activate Setup mode (SETUP key).
2. Now select „Invert" in the menu of Setup mode. You can now invert the
channels.
3. Select desired fixtures with appropriate Fixture keys. Several fixtures can be
selected at the same time for configuration.
4. Use the scenes keys, in order to individually switch the channels on or off. In
the display the respective condition will be shown as "Channel Inverted" or
"Channel normal".
5. If necessary press the PAGE key, in order to be able to change the further 8
DMX channels (channels 9-16).Repeat the steps 3 to 5, in order to configure
further fixtures.
Important:
The changes are not automatically stored but they are directly active. Therefore
it is necessary that you confirm the changes for durable storing once with the
RECORD or the SETUP key.
6. Press the SETUP key for 3 seconds, to leave the Setup mode again.
37/57