GLP SCAN OPERATOR FX II User Manual page 26

8. Repeat the steps 3 to 6, in order to configure further Fixtures
9. If the desired Blackout function is provided, then store it by pressing the
RECORD key.
10. Afterward press the BLACKOUT key. The procedure corresponds to the
sequence, as if you wanted to store a normal scene on the Blackout -Key.
11. For confirmation you will receive the message "Scene Saved".
12. Press the PROGRAM key for 3 seconds to leave PROGRAM mode.
Hint special case:
You should be certain that you only overwrite channels, which are not affected by the
Fade-Time (see Fade time attitudes).
This ensures, that when you deactivate a Blackout again, all channels directly jump
back to their current values.
If you overwrite a channel, which is affected by the Fadetime. the Fade time will be
applied to this channel when you switch the Blackout off, which then results in a slow
return from the Blackout Values for this channel. This case arises naturally only if the
Fade time function is being used, and if the Fader-Time Fader is not on position zero.
Otherwise this special case is insignificant.
26/57