Resetting The Blackout Function - GLP SCAN OPERATOR FX II User Manual

4.9.2 Resetting the Blackout function

With this function you can reset the Blackout to it's default values. This means that all
192 channels receive the status "on" and are overwritten the value "0". After the deletion
of the entire memory this is the case likewise (see above).
For setting the Blackout-Scene back you proceed as follows:
1. Activate PROGRAM mode (PROGRAM key)
2. Now select Bank 31 and/or the position, where the bank 31 would be. The
display now shows "overlay".
3. Keep the DELETE key pressed and press the BLACKOUT key at the same
time, in order to set the Blackout function back to its default values.
For confirmation you will receive the message "Blackout RESET". To set the
Blackout scene back, this is loaded automatically.
4. Press the PROGRAM key for 3 seconds to leave PROGRAM mode.
27/57