GLP SCAN OPERATOR FX II User Manual page 7

1. Fixture Buttons
and Selection LED
2. Scene keys
3. Fader
4. Page Select key
5. Overlay keys 1-6
6. LCD display
7. Bank keys
(UP/DOWN)
8. Record + Delete
key
9. PROGRAM +
Setup key
10. Speed/Sensitivity
Fader/FX Speed
Fader
11. Fade Time/FX
Size Fader
12. Pan/Tilt Encoder
+ Fine key
13. FREEZE key
14. Music/BankCopy
key
15. Auto key
16. Tap Sync /
12 Fixtures (Lamps) with 16 DMX channels each can be used.
The currently selected fixtures will be shown by their
corresponding fixture selection LED.
To access or to save scenes – press scenes key
Here you can adjust the DMX data of the respective channel.
Here you can switch the function of the Faders between
channels 1-8 (page A) or 9-16 (Page B).One LED shows the
current state.
Here you access the 6 Overlay scenes.
Shows all current information.
Here you can switch between the banks 1-30. These keys are
also there to change the start angle in the effect editor
Function-keys to record and delete
With these two keys you change the operation mode of the
Scan Operator FX II
Here you can adjust the automatic ... (0,12s – 12m 30s). This
Fader is also used to regulate the sensitivity of the microphone
(slow – fast) and the effect speed.
Here you adjust the Fade time (0 – 32s). The Fade time sets
the time it takes to crossfade between two different scenes or
of a chaser. This Fader is also there to change the size of a
chosen effect.
With the two encoders, you can directly adjust the Pan and Tilt
values of the selected fixtures. The Fine key allows you to
work accurate.
Turns on the DMX Freeze function.
Activates the Music Trigger or copies the whole Bank
Activates the Auto Trigger.
Allows you to manually trigger the chaser when in Auto Trigger
7/57