Using The Scan Operator Fx Ii; Overview; Operation Mode; Play Mode - GLP SCAN OPERATOR FX II User Manual

4 Using the Scan Operator FX II

4.1 Overview

This DMX controller allows to control up to 12 Fixtures with up to 16 DMX channels
each. There are 30 Banks with 8 Scenes per Bank.. Out of these 240 scenes you can
build up to 6 chasers with each up to 250 steps. The chasers and Banks can be recalled
in different ways:
 Manually
 Music Trigger
 Predefined Chase Time (Auto Trigger), that is given over the „Tapsync"-key or
Speed Fader
 MIDI command

4.2 Operation mode

All together there are 4 different operation modes in which different functions are
available. When you turn on the unit, you start directly in the play mode.
Hint: The current mode is always shown in the first line in the display!

4.2.1 Play Mode

This mode is there to play the scenes, banks and chasers you have programmed
before. There are different ways to let the banks and chasers tap automatically. The
Desk also reacts to given MIDI commands.

4.2.2 Program mode

It is possible to program the whole scenes, effects, banks, chasers, overlays and
blackouts in this mode.

4.2.3 Setup Mode

The Setup mode is used to configure the Scan Operator. You can configure the midi
channel, the midi control mode (between synthesizer and keyboard), reverse DMX
13/57