Rear Drive - MOTO GUZZI V1000 G5 Workshop Manual

III
REAR DRIVE
18.1 Removing the rear drive box (fig. 121 / 1)
Before removing any part from this, drain the oil
completely.
Do this by undoing the nuts securing the box to the
rear swing arm and withdrawing the box with gas-
ket .. 0 ...
Take oul the housing complete with p inion «E» and
seal .. F .. from the housing.
Remove cover «H», gaskets "L .. with spacer uM».
From the hollow spindle remove the rolier bearing
inner race using puller 17 94 83 60 (27 in fig. 122).
From the box remove spacer .. 0 .. , seat .. P», and
roller bearing ..
Q ...
Remove the outer roller bearing race using puller
12906900 (15
in
li9 . 123),
Housing components
To remove the nut securing the pinion to the hous-
ing, use tool 1290 71 00 (34 in fig . 124) and a hooked
wrench.
From the housing remove :
• beyel pinion and its shims :
•
taper bearings;
• bearing outer race by the aid of puller number
17945060 (40 in fig. 125):
•
•
bearing spacer;
bare housing .
{
Adlust teeth Clearance from 0.1 to
0.15
mm
(.0039+.0059")
Available shim sizes 0.8-0.9-1-1 .1-1.2-
1.3 mm (.031-.035-.039-.043·.047-.051")
121L-______________________________________________________________________
~
86