MOTO GUZZI V1000 G5 Workshop Manual page 110

9
tI-
(
7
5
6
4
3
br-,
2
1WL-________________________________________________________________
~
161
108
• Ensure the cush drive plate in undamaged.
• Ensure the cush drive rubber blocks have nol
hardened or crumbled.
• Check for any scoring of the brake disc.
• Ensure the bearing-flange ci rclip is still efficient.
• Check condition of the bearings.
• Ensure all spokes are properly tensioned and the
wheel is true.
Re-fitting the rear wheel an the swing arm and drive
box
Reverse the dismantling sequence ensuring caliper
plale ~ E .. (fig. 159) is inserted in the swing arm lug.
23.4 REAR WHEEL· 1000 SP
Removal (fig . 161 )
Proceed as follows :
• Set the vehicle up on the center stand .
• Loosen spindle securing nut «A» with waster «8-
from spindle "C,.; drive box side.
• Loasen screw .. D» securing spindle "C .. to the
swing fork arm.
• Withdraw spindle .. C .. from drive box, wheel hub,
and the swing arm.
• Withdraw plate .. E» complete with hydraulic ca-
liper and tubing, securing it to the frame tube.
• lean the machine to the right just sufficiently to
allow the wheel to drop off the swing arm and drive
box.