MOTO GUZZI V1000 G5 Workshop Manual page 95

&
-
$
¢ ..
L---------------______________________________________________
~ 1~
nion shim (see arrow .. 8 .. fig. 133/ 1).
If the contact is as shown at «4"
(fig.
134), the
pi~
nion is too far from the rotational axis of the crown.
Move pinion nearer to the crown and increase thick-
ness of the bearing-pinion shim (see arrow ,,8 .. fig.
133/ 1).
If the contact is as shown at «5» (fig. 134). the
crown is too far away from the rotational axis of the
pinion.
Approach the crown and reduce thickness of the
box-cover adjusting shims. Wi th a correct contact,
the pinion-crown clearance should be 0.10-0.15 mm
(.0039-.0059").
Assembling the box on the Ri H arm of the swing fork
•
Fit the wheel spindle spacer in the box.
• After fitting the sleeve and spindle on the pinion ,
position the seal on housing "G" (fig. 131). and slip
the rear drive box complete with shafts on to the
double cardan jOint and the 4 studs in the holes of
the swing fork right arm ",A", lig . 134.
• Insert rear wheel spindle ,,8» (fig. 134/1) through
the L/ H arm 01 the rear fork and the drive box.
• Tighten nuts "C" (fig. 134/
1)
wilh their washers.
Then withdraw wheel spindle " S .. which should co-
me out effortlessly.
If
il offers any resistance, it is necessary to loosen
nuts «C» and lurn the box 10 the right or to the left
until the spindle can be withd rawn from the box and
the swi ng fork arm without any effort.
93