MOTO GUZZI V1000 G5 Workshop Manual page 77

Layshalt
Should show up very smooth at its contact surfaces.
II scored or the threaded portions are stripped . re·
place the shall.
Sliding muff
Check smoothness 01 all sliding surfaces and en·
sure that the front engaging dogs are not damaged .
Gears on layshaft
Check teeth wear, also wear 01 the engaging dogs.
The teeth contact surlace should be quite smooth
and free from scoring or nicks. Replace the gears,
as necessary.
Roller bearing securing nul on layshalt
Ensure its thread is sti ll in good condition. II strip·
ped or damaged. replace the nut.
Bushings lor roller' cages · 1 st, 2nd, 3rd, and 4th
speed gears on layshaft
Check that the
su~ace
contacted by the cages is
not scored or nicked. Replace the bushing if not per·
feclly smooth,
Roller cages for 151, 2nd, 3rd, and 4 Ih speed gears
on layshalt
Ensure that all rollers in the cages are in good con·
dil lon or else replace the cages.
Sliding muff lorks
Ensure that all working surfaces are dead smooth
and not worn to such an exten t as to have lost their
original hardness. Also. that the pawls operating in
the drum splines are not unduly worn.
If
so. replace
the forks.
Gear selector drum
Check wear of the drum grooves contacted by the
selector forks.
If
too worn. replace the drum.
Gear seleclor pawls
Check straightness and wear and replace as naces·
sary,
Selector drum carrying rods and gearshift forks
Check straightness of the rods, ensuring they are
not damaged at the surface contacted by the forks.
If so, replace the rods.
Clutch shaft
Inspect splines. threaded sections, and slots. If worn
or damaged, replace the shaft.
102
75