MOTO GUZZI V1000 G5 Workshop Manual page 87

RefittIng the complete clutch unit on the main shaft
and In gearbox cover (fig. 103/ 1)
Refit :
•
inner body .. S .. ;
•
throwout bearing .. C .. on inner body ;
I
outer body .. 0 .. fitted with seal on gearbox cover
•
control rod .. F,. in the shaft, gearbox side ;
• complete operating lever on gearbox cover with
adjusting screw and locknut, also securing locknut
with cotter pins .. G .. ;
• lever return spring .. H.. in its housing in the
gearbox.
Fitting the complete gearbox with shafts and gears
on the engine group
To assemble the gearbox on the engine proceed as
follows :
• Fit the gearbox on the stud bolts of the engine,
taking care that the clutch inner body matches exac-
tly the two driven plates previously mounted.
• Screw i n the stud bolts and screws.
Adjusting the c lutch operating lever
After assembling the gearbox on the engine, adjust
the clutch operating lever as follows:
• screw i n or out adjusting screw .. B,. after loo-
sening counternut .. A". The distance to be obtained
from the gearbox cover to the center of the round
slot which retains the cable terminal is 75 mm (2.95")
(see " C .. in fig. 120).
85