Rear Wheel - MOTO GUZZI V1000 G5 Workshop Manual

Inspection
After completely strippi ng the hub, check for :lny
brake disc scoring and if the hub portion contact ing
the discs is not damaged. •
Check also condition of the wheel bearings and
if
any part is not perfectly efficient, replace it.
Be sure the wheel is quite true and there are no
axial clearances or wobblings (see fig. 158).
Re-assembling the wheel hub
Reverse the dismantling sequence, ensuring there is
no disc lIoating, checking this with a gauge.
Maximum allowed wobbling: 0.2 mm (.0078").
Tighten the securing screw nuts with a torque
wrench set to 2.2-2.4 kgm (16-18 ft./ lbs).
Re-assembling the wheel on the lork legs
Reverse the dismanlling operations. Ensure spacer
"0,, on spindle " F" is fitted on the R/ H side and spa-
cer "G" on the left (fi g. 156).
The spi ndle nut is lightened to 14-15 kgm (100-108
ft. l1 bs) with
a
torque wrench .
23.3 REAR WHEEl - V 1000 G 5
Removi ng the rear wheel from the swing fork arm
and rear drive box (fig, 159)
Proceed as follows :
• Undo the bolt securing the
L/ H
muffler to the
frame, remove cli p and the muffler from the exhaust
pipe.
• Undo nut .. 8» on the spindle drive box side.
• Loosen spindle securing boll
«C ..
to swi ng fork
arm ,
• Remove spindle " D .. from rear drive box , hub
and swing fork arm.
• Remove brake disc from caliper " E».
• Slip off plate and caliper complete with piping
and secure it to the frame l ube.
• lean the machi ne to the rig ht just su fficiently to
allow wheel «F» to drop out.
Stripping the rear wheel hub (fig, 160)
Remove screw «1», washer ,,2» , and lockplate ,,3 ...
Remove circlip «4» , cush drive plate "5,, and rubber
blocks «6 ...
Undo nuts .. 7 .. and remove screws ,,8»,
Withdraw brake disc .. 9 ...
Remove seal "10» , flage «11», and from this, seal
.. 12», bearing .. 13" and from the other side bearing
.. 13 .. , washer «14», gasket «IS» , and finally spacer
.. 16 ...
Inspection
• Ensure the cush plate retaining circlip has not
lost its elasticity.
Parallelism
03mm (.0118'") . 1
Oll$el
03mm ')
Concen triC, ly
03mm (OIlS'")
i i
mm (.01 ')
Ollse t
Concenldcily
0.3 (0118")
The adm,$$,ble
erlor '5
158
\ D
r
159
107