MOTO GUZZI V1000 G5 Workshop Manual page 82

111 / 1
mm2
mm 2.1
!~~~::! >--,
mm2.2
mm 2.4
Then fit the selector spindle on the cover and tigh-
ten eccentric screw "B .. with locknut «A» on the
cover (fig. 118).
Re-fitting the gearbox components
All parts to be fitted in the gearbox are assembled
with the following sequence :
Re-fittlng the main shaft in the box
Before re-assembling the main shaft in the box, it
should be shimmed so that between the gearbox
bearing and cover bearing there is a distance of
167.1-167.2 mm (6.578-6.582") (see fig. 112).Thi s di-
stance is obtained with shims which are avai lable
in the fallowing sizes 2-2.1-2.2-2.4 mm (.078-.082-.086-
.094") (see fig. 112). The shims are fitted between the
gearbox bearing and the throwout bearing.
After shimming, press the roller bearing race on the
shaft using tool part N. 17 94 54 60 (32 in fig . 113).
Layshaft
Before assembling this, it is necessary to fit on it
the sliding sleeves and gears as follows:
On the shaft, g~arbox end
• insert the second speed gear bushing on the
shaft. making sure the bush head faces the gear box
cover;
• roller cage for the 2nd speed gear on bushing;
• 2nd speed gear on the cage with front engaging
dogs turned towards the gearbox cover;
•
shim between 2nd and 3rd speed gear:
• 3rd speed gear and roller cage with its enga-
ging dogs facing the gearbox cover:
•
rolier cage for 3rd speed gear on bushing;
• 3rd speed gear bushing with its head facing the
sliding sleeve:
167.1 + 167.2 (6.578+6.582")
112L-________________________________________________________________
~
80