MOTO GUZZI V1000 G5 Workshop Manual page 86

118
.-
--0
J
Filled with loctite
mm 0.6 (.023")
mm
0.8 (.031")
mm 1 (.039")
mm '.2 (.047")
and between gearbox cover and drum,
jf
2 nd and
4th gear do not engage smoothly.
Shim sizes available for this operation are: 0.6, O.B,
1, and 1.2 mm (.023, .031, .039, .047") see fig . 119.
After shimming refit the cover as above described
and check again
jf
all gears engage properly.
If
so.
lock the layshaft nul tightly using tool
N. 1490 54 00 (35 in fig.91) and layshall holdlasl
tool 1290 7100 (34 in ltg, 91) .
After lightening this nut, hammer it with a chisel in
correspondence of the shalt groove to lock it com-
pletely.
Tighten the cover securing screws and remove the
tool previously fitted on the selector shafl. Insert the
operating lever in the selector shaft and lighten its
securing screw.
Lock tightly the oil breather plug which is also the
retainer of the spring and stop pin on the gearbox.
Retitting the Inner body and clutch unit on shaft
Assemble:
• bearing-inner bOdy seal:
• Inner body;
• safety washer;
• inner body locking nut on clutch shaft. Tigh ten
this nut using tool N. 14912800 (36 in fig. 94) and
hook wrench N. 14912600 (37 in fig. 95);
• bend one ear of the lock plate in one of the lock-
nut grooves.
119 L-____________________________________________________________
~
84