MOTO GUZZI V1000 G5 Workshop Manual page 80

104 L-_ __ _ _ _ _ _ - - - - - - - - - '
105L-____________________________ --"
, - .-...
106L-____________________________ --"
78
• The outer race 01 layshafl bearing is pressed in
by the aid of punch N. 14929100 (44 in fig. 105).
• Main shaft bearing is pressed in with punch
14928800 (45
in
fig. 106).
Pressing of bearings In gearbox cover housings
After smearing with Leclile, press the layshaft bea-
ring in its housing by the aid of punch 14 92 89 00
(43 in fig. 107).
The main shaft bearing is pressed in with punch
14929000 (46 in fig.
108).
The clutch shaft bearing is pressed in with punch
N. 149288 00 (45
in fig .
109).
After pressing the bearings into their housings, leave
them to rest for about 12 hours to allow the Loctite
compound to dry up completely before proceeding
with re-assembling the other gearbox components.
Assembling the clutch shaft bearing retainers in the
gearbolC and the layahalt bearing retainers In
the cover
Ensure these retainers are perfectly adherent to
the bearing outer race. The threaded portion of
the retainer bolls should be smeared with l octite
N. 00 01 0400 (59 in fig . 35) before tightening.
Fitting 01 gearbolC seals for clutch shalt and seals In
cover for layshalt and selector shalt
The seal for the clutch shaft in the gearbox is fit-
ted using punch N. 14929400 (47 in fig . 110).
107