MOTO GUZZI V1000 G5 Workshop Manual page 22

6/ '
20
on a warm engine as in such condition the oil is fluid
and more easy to drain. Do nol forget to let the old
oil drain fully before any fresh one is introduced .
.. A,. - filler cap .
.. a" - inspection hole cap.
"G .. - drain plug .
Quantity required : 0.750 Its. (ab, t .
W.
pints us) AGIP
F. 1 Rotra MP oil SAE 90.
4.4 LUBRICATION OF REAR DRIVE BOX (fig. 7)
Checking the all level
Every 3000 km (2000 miles) ensure the oil level is
nearly up to inspection hole .. A .. ,
If
lower, top up with
oil of same brand and density.
Oil change
Every 10.000 krn (6000 mites) replace the oit in the
rear drive box .
This replacement is best done on a warm engine
when the oil is easier to be drained .
l ei
the old oil
drain fully before adding fresh oil.
<c A,. Level control cap .
.. 6 .. fi ller cap.
" C .. Drain plug.
Quantity required : 0.250 Its. (abl.
8 '/~
oz) of which
0.230 Its. (abt. 8 oz) Oil Agip F. 1. Rotra MP SAE 90
and Its. 0.020 (about
'/~
oz) Agip Rocol ASO / A. (Mo-
Iykole type «A» ).
4.5 FORK (LUBRICATION (fig . 8 and 9)
To replace the oil in the fork legs, proceed as follows :
• Undo drain plug with gasket .. A ...
• Undo bolt .. 8 ".
Before introducing fresh oil. iet the fork legs drain
fully.
" A" Fluid drain screw .
.. 8" Fluid filler cap.
Quantity required : 0.090 lIs. (ab!. 3 oz.) each leg . Oil :
AGIP F. 1 ATF Oexron .
Lubric ation of the steering and rear fork bearings
For this operation use "AGIP F.1 Grease 30 .. .