Master Cylinder - MOTO GUZZI V1000 G5 Workshop Manual

'691. ____________
~
____
_ = ~
_ _ _ _
~ _ ~
, - -
1S Refit the complete master cylinder on the R/ H
side handlebar, the twist grip control , and the start-
slop switch.
16 Connect the lIuid delivery pipe from caliper to
master cylinder body.
17 Check clearance between floater and lever end
on the right front brake master cyli nder.
18 Fill up fluid reservoir and bleed the air from the
braking circuil.
19 Refit
gait~r
«9» and screw in plug «12".
Note - Before mounting moisten all metal and rubber
parts with brake fluid or recommended grease . Ne-
ver use minerai oils or greases.
23.12 MASTER CYLINDER FOR LEFT FRONT
AND REAR BRAKES (fig. 173)
It is centrally located on the R/ H side of the vehicle.
Remove the R/ H side cover to get access to it.
Ensure there is a 0.05-0.15 mm (.0019-.0059") clea-
rance between floater and lever end on the master
cyilinder If not. adjust to correct clearance.
Periodically lubricate scraper ring u9» and floater
stem .. 5" , using brake fluid . Under no circumstan-
ces whatever mineral oils or greases should be
used.
2 • Master cylinder body
3 - Piston return spring
4 -
Piston
5 - Lip seal
6 - Piston stop washer
7 -
Wiper ring
8 •
Wiper ring
SlOP
washer
9 - Bellow
12 • Plug, complete
13 - lever adjusting screw
14 • Cri nkle washer
15 - lever Ibeing screw
16 - Washer
17 - SeU locking nul
18 • Master cylinder 'ix lng s crew
14 13
'70L-______________________________________________________________________
~
116