MOTO GUZZI V1000 G5 Workshop Manual page 30

26
27
28
28/' I l \ . .
28
II
MAINTENANCE OPERATIONS AND
ADJUSTMENTS
6.1 ADJUSTING THE CLUTCH LEVER PLAY (fig. 26)
If the handlebar play at the handlebar lever is more
or less than 3-4 mm (abl.
l/
t "),
operate on the thumb
screw to obtain the correct play. This adjustment can
also be made by slackening locknuts .. C .. and ope-
rating on cable adjuster "8,, on the right side of the
gearbox.
6.2 ADJUSTING THE RIGHT FRONT BRAKE LEVER
{fig.2n
Proceed as follows :
• Fit
a
feeler gauge .. A .. between Iloaler in master
cylinder and the control lever end . Then turn thumb
screw "B,. to 'obtain the correct play (0.05-0.15 mm
=
.0019-.0059"),
6.3 ADJUSTING THE FRONT lEFT AND REAR
BRAKE PEDAL
(fig.
28 and 28/ 1)
Check the floater-lever end play (G) as follows:
Fit
a
feeler gauge between master cylinder floater
and the operallng lever end and act on eccentric
screw ",A». Correct play is 0.05...{).15 mm (.0019-.0059").
6.4 ADJUSTING THE REAR SUSPENSION (fig. 29)
The ex.ternal springs of the rear suspensions can be
ad justed
10
3 positions by means of wrench .. A".
In case of faulty damper operation. have them che-
cked by our dealers.
0 0 not f org et that the two springs have to be adju-
sted to the sa me position to ensure good ve hic le
stability.
6.5 ADJUSTING THE STEERING (fig. 30 and 30/ 1)
For sale riding the steering has to be adjusted so
that the handlebar can move freely without any play.
• loosen steering head bolt .. A".
• Undo steering head nut «8».
• Screw adjusting nut " C» in or out unti l the cor-
rect play is obtained.
After adjusting. re-tighten nut «8» and top steering
head bolt «A».
6.6 ADJUSTING THE THROTTLE TWIST GRIP
(<<0» and .. C .. in fig. 14)
To adjust the grip travel , screw in or oul adjuster
..0" .