Brake Pads - MOTO GUZZI V1000 G5 Workshop Manual

13--.
9 12 "
6
3
10
2 _ Hall caliper, right and left. without lugs
3 - Hall caliper, right and leU, with lugs
4 _ Seal
5 - Pislon
6 - Dusl washer
7 - Gasket
8 - Caliper joinmg IIcrew
9 - Pads
10 - Pad retaining pm
11 _ Pad posilioning spritlO
12 - Pad positioning pin
13 - Pad protection cover
14 - Drain plug
15 - Dust cap
176L-________________________________________________________________
~
177
120
Caliper for rear b rake - 1000 SP
Max cylinder housing dia. 48.071 mm (1.890").
Max piston dia. 47.936 mm (1.887").
10 Fit a new gasket in cylinder housing groove.
11 Fit piston in cylinder housing (introduce this by
finger pressure only).
12 Fit dust guard cap checking for any damage and
secure it in its housing on both piston and caliper
bodies.
13
Join the two caliper bodies, taking care that
the
gasket is properly lodged in its housing. Tighten the
screws to a torque wrench load of 4--4.5 kgm (29-
33 tbs f ft) .
14
Reassemble caliper on fork member, screwing
in its securing screws to a torque wrench load of.
4
+
4,5 kgm (29-33 Ibs 1ft) .
15 Fit pads on pins. pin retainer. and spring with
tapered pin.
16 Connect rluid delivery pipe to caliper.
17 Bleed the air from the braking circuit. 0 0
not
use minerai oils or g reases.
23.15 BRAKE PADS
Brake pads are marked as follows :
V 1000 G 5
• front right and rear (whi te) FERIT I D 332 GG ;
• front left (red)
FERIT
110 330 FF.