MOTO GUZZI V1000 G5 Workshop Manual page 107

ED
WHEELS
23.1 REMOVING THE FRONT WHEEL · V 1000 G 5
(fig. 154j
• Fit stand part N. 1891 2450 (1 in fig.35) under
the engine.
• Undo bolts «F» and .. G,. that secure cal iper «A»
to the L/H leg cover and by lightly raising the cali-
per withdraw it from the brake disc .
• Undo spindle nut ,,8 .. on the R/ H side.
• Loosen the spindle-leg cover securing screw .. C .. .
• Take out spindle .. 0 .. .
• Take of the brake disc from the caliper bolted
on the R/ H fork leg.
Removing the front wheel hub (fig . 155)
Operate as follows :
Undo nuts «1" o n
the
braking disc securing screws
to hub .. 3», and take out screws «2» and spacer .. 7 ...
Remove both drake disc spacing flanges ,,4 .. and
from these remove bear ings .. 5". circlip, .. 6 .. and
finally bearing spacer ,,8 .. ,
Inspection
After stripping the hub, check the brake discs for
scoring , also that the ftange joining face is not da-
maged and the circlip still efficient. Replace, as
necessary.
Re-assembling the front wneel nub
Reverse the dismantli ng sequence except that it is
necessary to check wobbling of the disc with a
proper gauge.
Maximum wobble : 0.2 mm (.0078" ).
154
L -____________________________________________________________
~155
105