MOTO GUZZI V1000 G5 Workshop Manual page 106

149
150
151
104
22.3 PRESSING THE OUTER RACES ON THE
SWING ARM TAPER BEARINGS
Press these in by the aid of punch N. 1794 52 60 (33
in
fig. 151).
22.4 PRESSING THE BEARINGS INTO THE R/ H
ARM OF THE SWING FORK
Press this bearing in using punch 17 94 53 60 (31 in
fig. 152).
22.5 ADJUSTING THE SWING ARM PLAY
(fig.
153)
Ensure the swing fork oscillates freely without any
play_
Be sure both spindles project by the same amount.
This adjustment is best done using a screwdriver
«A» and gauge .. e ...
152
153