MOTO GUZZI V1000 G5 Workshop Manual page 147

24.14 LIGHTING EQUIPMENT AND HORN - V 1000
GS
a Bulb replacement
Headlight (fig . 199)
Loosen cottom screw
" B".
disconnect headlight in-
sert and replace the bUlb.
b Tail light (fig .
200)
Undo screws "D" securing the reflector to the tai l
light housing , press the bulb inwards and twist it at
the same time to take it out.
c TUrn signals (fig .
200)
Loosen screws ..
E"
securing the rellectors to the sig-
nal light housing. press the bulb in and twist it at
the same time to take It out.
d
Number plate light (fig .
200)
Loosen screws "F~ securing the transparent part to
the housing. Press the bulb inwards and twist it at
the same time to take it out.
Caution · When re-fitting Ihe reflectors onto the tail
light, number plale light , and turn signal lights , do
not screw in
100
tighlly to avoid breaking the reflec-
lor.
e Instrument panel, tachometer, and rev-counter
Take out bulb holders from panel . tachometer, or
rev-counter, and remove the bulbs .
Bulbs (12 V)
Headlight
• high and low beam 45/ 40 W;
• town driving or parking 4 W;
Tail tight
• parking and stop fight 5/ 21 W :
• number plate light 5 W;
Turn signals 21 W;
Panel warning lights 1.2 W;
Tachometer and rev-counter light 3 W.
9 Etectric horns
The horns ci rcuit includes :
• high pitched tone horn :
• low pitched tone horn :
• ground on frame.
Horn features
Combined horn . Belli make.
High pitched horn (90/ 12/ 2) . absorption 3 A.
Low pitched horn (90 / 12/ 4) , absorption 4 A.
Total combined absorption : 7 A.
24.15 LIGHTING EQUIPMENT AND HORN - 1000 SP
a Bulb replacement
Headlight (fig. 201)
Undo bottom screw .. D~ . remove both bulb holders.
and replace bulbs.
199
200
141