MOTO GUZZI V1000 G5 Workshop Manual page 26

14
15
16 _ _ -'
16/ 1
24
5.6 ENGINE STARTING AND EMERGENCY STOP
BUTTON (Iig . 14)
Right,
on
the handlebar. With ignition key in position
.. A .. , the
engine is
ready 10 be started.
To start the engine proceed as follows:
• Ensure switch ,, 8 .. is in position ..
1».
• Pull clutch lever fully.
• On a cold engine, set easy starler lever on .. A ..
(fig.
20)
• Push start button . A .. ,
To stop the engine (in case of an 8!flergency). move
switch .. 8 ,. in position .. 2 .. ,
After slopping the engine, lurn the ignition key anti-
clockwise until mark .. OFF .. is in line with the panel
mar k, and withdraw the key.
5.7 EASY STARTER LEVER (fig. 20 and 20/ 1)
The control lever for starling a cold engine is located
on the L/ H side of the vehicle .
.. s ,. Starting position.
" C.. Rid ing position.
5.8 THROTTLE CONTROL GRIP (~ E " fig. 14)
Right , on the handlebar. Throllle is opened by turning
towards the r ider and viceversa.
5.9 CLUTCH CONTROL LEVER
It is on the left handlebar and should be used only
for starting and gearshifling.
5.10 RIGHT FRONT BRAKE CONTROL LEVER
(" Fl O fig.
14)
Right, on the handlebar. It controls the front right
master cylinder.
5.11 TWIN BRAKE CONTROL, FRANT LEFT AND
REAR ("A .. fig. 15)
The con trol pedal is located on the R/ H side of the
motorcycle and is link connected 10 the master cy·
linder (fuel reservoir). II operates both front left and
rear brakes al the same lime.
5.12 GEARSHIFT PEDAL (fig. 16 and
16 / 1)
It is centrally located on the L/ H side of the machine.
• 1st gear = pedal downwards.
• 2nd, 3rd, 4th, and top gear
=
pedal upwards.