Adjusting The Headlight Beam - MOTO GUZZI V1000 G5 Workshop Manual

To adjust the grip return, screw in or out adjuster
.. C».
6.7 ADJUSTING THE WHEEL SPOKES · V 1000 G 5
Ensu re that all spokes are properly tensioned and
that the wheel rim is quite true.
Proceed as follows:
• Turn the wheel and using a locator, check if the
wheel is offset. If necessary tighten or loosen the
right or left spokes till Ihe wheel lurns without any
wobbling. This check should be done after the firsl
SOD km (300 miles) and then every 1500 km (900
miles).
6.8 ADJUSTING THE HEADLIGHT BEAM
V 1000 GS (fig. 31)
For safe riding and in order not to disturb crossing
riders, the headlight beam has always to be set al
correct height.
Horizontal setting is adjusted by undoing screw .. A»
while vertical setting is adjusted through screw ..
C~
and moving the headlight up or down unti l the cor-
reel height is obtained . The center of the high beam
must not be higher than 0.870 meters (34") measured
at 39,8 fb meters distance with motorcycle off the
stand and the rider on the saddle.
6.9 ADJUSTING THE HEADLIGHT BEAM - 1000 SP
(fi g. 32)
for safe riding and in order nol to trouble crossing
riders, the headlight should always be set at correct
height.
Horizontal setting is adjusted by screw ,,0» while
vertical setting is adjusted by acting on the screw
which secures the headlight to the fork covers until
the correct height is obtained.
The center of the high beam must not be higher than
0.875 meters (34.4") measure at 3 meter (9.8
ttl
di-
stance with the machine off the stand and the rider
on the saddle.
2' '''_'':
30
32
29