FUEL SYSTEM
3.1.3.
CYLINDER SYNCHRONISATION
•
With the vehicle engine switched off, connect the
Axone 2000 instrument to the diagnostics connector
and the vehicle battery.
•
Switch on the instrument.
•
Screw the unions for connection of the vacuum meter
lines to the threaded bores on the intake pipes.
•
Connect the vacuum meter lines to the respective
unions.
•
Set Axone to the adjustments-setup page
•
Make sure that the throttle is at the stroke end position
•
Execute the throttle position self-teach procedure
•
Set the ignition key to "OFF" and leave it in this position
for at least 30 seconds
IMPORTANT Do not touch the throttle end stop screw,
otherwise the throttle body must be renewed. Check that the
throttle return cable is not taut
•
Start the engine.
•
Bring the engine to the prescribed temperature:
50 °C (122 °F).
•
Completely close the two bypass screws on the throttle
bodies.
3 - 6
NEVADA 750 i.e.