Selecting Live Mode And Pushing Or Pulling Data - Extron electronics DMP 128 User Manual

selecting Live Mode and Pushing or Pulling Data

To switch from Emulate to Live mode:
1. Select the desired connection to the DMP 128 and make the proper connections.
notE: Extron recommends connection via the Ethernet LAN port when using
DSP Configurator.
2. Click Live (see figure 57, b ). The communication type selection dialog opens.
2
3
4a
4b
4c
Figure 57.
3. To select the connection method, click:
TCP/IP (for connection of the LAN port (preferred) — proceed to step 4
•
RS-232 (for connection of the rear panel RS-232 port — proceed to step 5
•
USB (for connection of the front panel configuration port — proceed to step 6
•
4. If TCP/IP is selected in step 3:
a. Observe the IP address field in the IP connection dialog box. The field displays
the last IP address entered.
•
•
b. If the device is password protected, click in the Password field and enter the
appropriate administrator password
c. Click OK
The Synchronize with Device dialog box (see figure 58 on page 92) opens.
Proceed to step 7.
3
5a
or 5b
5c
Selecting Live mode
If the IP Address field is correct, proceed to step 4b
If the address is not correct, either click in the IP Address field and
enter the correct IP address or click ( ) to open a drop-down list and select
from among recently used addresses. Proceed to step 4b
notE: If the local system administrators have not changed the value,
the factory-specified default, 192.168.254.254, is the correct value
for this field.
3
Extron USB device
or
6b
DMP 128 • Software Control
6a
90