Selecting Live Mode And Pushing Or Pulling Data - Extron electronics DMP 64 User Manual

Selecting Live Mode and Pushing or Pulling Data

To switch from Emulate mode to Live mode:
1. Select the desired connection to the DMP 64 and make the proper connections.
NOTE: Extron recommends connection with the Ethernet LAN port when using
DSP Configurator.
2. Click the Mode
selection window appears.
2
3
4a
4b
4c
Figure 52.
3. Click one of the following tabs:
•
TCP/IP
•
RS-232
step 5, or
•
USB
4.
If TCP/IP is selected in step 3:
a. Observe the
last IP address entered.
•
•
b.
If the device is password protected, click in the Password field and enter the
appropriate administrator password.
c. Click OK.
The Synchronize with Device dialog box (see figure 53 on page 79) opens.
Proceed to step 7.
button, (see figure 52, b ). The
Live
3
5a
5b
or
5c
Selecting Live Mode
for connection using the LAN port (preferred) — proceed to step 4,
for connection using either of the rear panel RS-232 ports — proceed to
for connection using the front panel configuration port — proceed to step 6.
field in the IP connection window. The field displays the
IP Address
If the IP address is correct, proceed to step 4b.
If the IP address is not correct, either click in the
the IP address or click the drop-down arrow to open a list and select from a
recently used address. Proceed to step 4b.
NOTE: If the local system administrators have not changed the
address, the factory-specified default, 192.168.254.254, is the correct
value for this field.
Communication Type
3
Extron USB device
or
6b
field and enter
IP Address
DMP 64 • Software Control
6a
77