Introduction; About This Guide; About The Dmp 64 Digital Matrix Processor - Extron electronics DMP 64 User Manual

Introduction

This section describes this manual and the DMP 64, including:
•
•
•
•

About This Guide

This guide contains installation, configuration, and operating information for the
Extron Electronics DMP 64 ProDSP
audio processor.
In this guide, the DMP 64 can also be referred to as "the mixer" or "device."
About the DMP 64 Digital Matrix Processor
The DMP 64 is a standalone audio matrix processor with six microphone/line inputs and
four line outputs. Using high-quality 24-bit A/D converters sampling at 48kHz, input signals
are converted into the digital domain where Digital Signal Processing algorithms process
and mix the signals using Extron floating point ProDSP
a dual-matrix design providing virtual processing busses, with audio signal processing
available in any of the input, virtual, and output signal paths. A dual matrix mixer with virtual
paths provides extremely flexible architecture, allowing for versatile processing, mixing, and
routing scenarios.
The DMP 64 is IP Link
fast configuration and setup. Dual RS-232 ports on the rear panel, plus a USB port located
on the front panel provide convenient high-speed access. Six digital I/O ports permit
connection of switches and sensors to provide input to the system for triggering a variety of
actions within the device.
The DMP 64 has no front panel controls therefore, all configuration is performed using
the Extron DSP Configurator
communication ports: RS-232, USB or Ethernet. Signal present and clip LEDs for the six
input channels and four output channels are provided on the front panel.
Two operational modes, Live and Emulate, allow a user to work offline from the device to
set up a configuration and create presets and group controls as needed before placing the
configuration in the DSP 64. DSP Configurator settings developed offline can be saved to
disk as a job file to be uploaded to the device at a later time, or can be transferred directly
to the device by switching to Live mode. Up to 32 full or partial presets and up to 32 group
master controls can be created, loaded into, and stored in the DMP 64. The presets and
controls can then be recalled through DSP Configurator, or a control system using Simple
Instruction Set (SIS
232 or Ethernet can control a limited subset of DMP 64 functions using SIS commands.
About This Guide
About the DMP 64 Digital Matrix Processor
Features
DMP 64 Application Diagram
-enabled, connecting to a host computer via the Ethernet port for
®
program from a host computer connected by any of the
™
) commands. Control systems connected to the device either by RS-
™
Digital Matrix Processor, software-controlled digital
™
technology. The DMP 64 uses
™
DMP 64 • Introduction 1