Dmp 128P At Expansion Bus (At Inputs) - Extron electronics DMP 128 User Manual

The DMP 128 output lines are always the first eight transmitter lines (Outputs 01
through 08 in figure 77, d ). The eight expansion outputs (see figure 76, b on the
previous page) appear in the Dante transmitter list (item d , below), as EXP_Out-01 to
EXP_Out-08). The eight virtual sends of the DMP 128 (figure 76, c ) appear as EXP_
Out-09 through EXP_Out-16.
Figure 77.
DMP 128P at Expansion Bus (at inputs)
Dante
There are a total of 56 DMP 128 EXP inputs that can be routed.
Receivers
Dante Receivers (Rx)
5
Figure 78.
In figure 78, expansion inputs that accept signals on the AT bus from the Dante receiver
channels are outlined.
notE: Figure 78 shows only the first 16 of 56 total expansion inputs. Routing of
inputs not shown is the same.
Dante Transmitters
DMP Expansion Bus AT Inputs
DSP Configurator Expansion Inputs (Dante Receiver EXP_In)
Dante
Transmitters
4
Connection
6
Points
AT Inputs 17 to
AT Inputs 56
DMP 128 • Software Control 123