Device Discovery - imagistics ipc1-im6530 Administrator's Manual

the supporting workstations. In some cases, you need to add or update
network components.
The following checklist helps you identify the source of the error and
directs you to where you can find more information about resolving it. If
the problem persists after you have followed all of the steps, contact a
Imagistics authorized dealer for further assistance.
Troubleshooting Checklist
Possible Cause
Networking
(protocol)
limitations or errors
Unreachable
network segment
254

Device Discovery

Check
1 Confirm that the protocol
suite installed on the client
workstation has been
updated with the latest
software for the given
operating system. If your
network only supports the
IPX/SPX protocol, make sure
that the most current version
of Novell Client software is
installed.
2 Print a startup page from the
copier. Does the controller
support the same protocol as
the network?
3 Change the protocol settings
from the copier control panel,
if necessary, and reboot the
controller for the changes to
take effect. Repeat Step 2.
Was the device discovered?
4 Check the controller startup
page. Are the IP Address
and subnet mask settings
correct?
im6530, im8130
Yes
Next
Step
↓
Next
Step
↓
End
Next
Step
↓
ipc1-im8130 Administrator's Guide
For Instructions,
No Go To...
→
See the vendor's Web
site for information
about product updates
and technical support.
→
Modifying
Controller Settings
at the Control
Panel
on page 11.
Modifying
Next
Controller Settings
Step
↓
at the Control
Panel
on page 11.
→
Modifying
Controller Settings
at the Control
Panel
on page 11.