Printing To The Controller In Unix - imagistics ipc1-im6530 Administrator's Manual

1 After you install the filter, run the command: find / -name
net_ipc1im8130.
2 Run the command more <PATH>/net_ipc1im8130. This file contains
all of the valid options that you can use.
Use these commands as follows:
Locate the command of interest. For example:
nobanner | nb )
banner="none"
The valid option to enter into the <queue name>.conf file is:
banner="none"
With some of the options you have to set more than one parameter. For
example, for booklet printing, locate
booklet=letter | booklet=lt | booklet=LT )
The valid option to enter into the <queue name>.conf file is
The values stored in this file are case sensitive and they must conform to
the /bin/sh variable format.

Printing to the Controller in Unix

LP Command
Use the lp command (lpstat in Linux) to send a file to the controller for
printing. This command specifies various printer-specific options using
the -o option parameter on the command line. The lp command also
sets other print options using various other parameters. Use the man
net_ipc1im8130.1 command to view the online document that describes
the various options and parameters that you can set to configure printed
output.
All the options are sent to the controller at the start of a print job so, if the
print file contains its own commands, they may override the lp options.
164
booklet="LT"
booklet_paper="LETTER"
booklet="LT"
booklet_paper="LETTER"
im6530, im8130
ipc1-im8130 Administrator's Guide