imagistics ipc1-im6530 Administrator's Manual page 120

8 To set the controller as a master browser, click the
down list and select
9 Click
10 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Configuring AppleTalk Settings
If you are using the AppleTalk networking protocol for any network traffic
involving the controller, you must enable the AppleTalk protocol on the
controller. The AppleTalk protocol is enabled by default. If you are not
using AppleTalk for any network traffic, disabling the AppleTalk protocol
on the controller reduces overhead and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the AppleTalk area, click the
5 Select
6 Enter the
7 Click
8 If you change the TCP/IP protocol settings or enable/disable a
network card, you must reboot the controller before the changes take
effect.
For information on rebooting the controller, see
Controller
Restoring Default Protocol Settings
You can restore the network settings to their default values. Restoring the
defaults returns the controller to the state it was in when it was delivered.
98
im6530, im8130
Enable
.
Save
on page 30.
link. The Network page opens.
Network
to enable AppleTalk. This is the default setting.
Enable
string.
AppleTalk Zone
.
Save
on page 30.
. The default setting is
subtab.
Setup
drop-down list.
Protocol
ipc1-im8130 Administrator's Guide
drop-
Master Browser
.
Disable
Rebooting the
Rebooting the