Installing The Optional Memory Module Dimm - Kyocera Mita KM-2530 Service Manual

1-2-3 Installing the optional memory module DIMM

Memory module DIMM installation on the fax control PCB requires the following parts:
8 MB memory module DIMM (P/N: 2AW6001)
<Procedure>
1. Remove 13 screws and take off the rear cover.
2. If the printing system is installed, remove the 2 screws and pull the
printing system out of the controller box.
3. Remove 13 screws and take off the controller-box cover.
Rear cover
Figure 1-2-22
Printing system
Screws
Figure 1-2-23
Controller-box cover
Figure 1-2-24
3DB
Screws
Screws
1-2-11