Kyocera Mita KM-2530 Service Manual page 177

Problem Causes/check procedures
(19) Check if the registration
A paper jam in the clutch malfunctions.
fixing section is indi-
cated during copy-
Electrical problem with the
ing (jam in fixing
registration clutch.
section).
Jam code 40
(20) Broken eject switch actua-
A paper jam in the tor.
eject section is indi-
Defective eject switch.
cated during copy-
ing (jam in eject
section).
Jam code 50
(21) Broken feedshift switch
A paper jam in the actuator.
eject section is indi-
Defective feedshift switch.
cated during copy-
ing (jam in job sepa-
rator* eject section).
Jam code 51
Broken job separator eject
switch actuator.
Defective job separator
eject switch.
(22) Check if the feedshift sole-
A paper jam in the noid malfunctions.
feedshift section is
indicated during
Electrical problem with the
copying (jam in
feedshift solenoid.
feedshift section).
Jam code 52 Broken feedshift switch
actuator.
Defective feedshift switch.
Defective registration
switch.
Check if the registration
clutch malfunctions.
Electrical problem with the
registration clutch.
*Optional.
Corrective measures
Run maintenance item U032 and select the registration clutch
on the operation panel to be turned on and off. Check the status
and remedy if necessary.
Check (see page 1-5-54).
Check visually and replace the eject switch if its actuator is bro-
ken.
Run maintenance item U031 and turn the eject switch on and off
manually. Replace the eject switch if indication of the corre-
sponding switch on the operation panel is not displayed in re-
verse.
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn the feedshift switch on
and off manually. Replace the feedshift switch if indication of the
corresponding switch on the operation panel is not displayed in
reverse.
Check visually and replace the job separator eject switch if its
actuator is broken.
Run maintenance item U031 and turn the job separator eject
switch on and off manually. Replace the switch if indication of
the corresponding switch on the operation panel is not displayed
in reverse.
Run maintenance item U033 and select the feedshift solenoid on
the operation panel to be turned on and off. Check the status
and remedy if necessary.
Check (see page 1-5-54).
Check visually and replace the feedshift switch if its actuator is
broken.
Run maintenance item U031 and turn the feedshift switch on
and off manually. Replace the feedshift switch if indication of the
corresponding switch on the operation panel is not displayed in
reverse.
Run maintenance item U031 and turn the registration switch on
and off manually. Replace the registration switch if indication of
the corresponding switch on the operation panel is not displayed
in reverse.
Run maintenance item U032 and select the registration clutch
on the operation panel to be turned on and off. Check the status
and remedy if necessary.
Check (see page 1-5-54).
2DF
1-5-23