Kyocera Mita KM-2530 Service Manual page 601

11. Fit the catch on the auxiliary power unit into the mount hole in the
copier, and fasten the auxiliary power unit into place with one M3 ×
06 chrome binding screw.
12. Through the opening of controller-box above the speaker, connect
the FAX-PCB-Power cable on the auxiliary power source PCB
assembly to connector YC8 on the fax control PCB.
13. Connect the 2-pin connector to the 2-pin connector with green
cable.
14. Unlock YC1 on the fax control PCB by pulling its connector
housing.
15. Hold the fax cable with its conductive side facing up, insert it into
connector YC1, then push the housing back in to lock the
connector.
16. Hold the other end of the fax cable with its conductive side facing
down, and connect it to connector CN44 on the main PCB. (Pull
the CN44 housing out to release the connector lock, then insert the
cable, and then push the housing back in.)
Important: Be sure to push the fax cable all the way in, and be sure
that the connection is straight. A poor connection may result in a
variety of problems.
17. Refit the controller-box cover.
Catch
Figure 1-2-11
Fax control PCB
YC8
FAX-PCB-Power
cable
Figure 1-2-12
CN44
Fax cable
Fax control PCB
Figure 1-2-13
3DB
M3 × 06 chrome
binding screw
Mount hole
Opening
2-pin connector (green cable)
2-pin connector
Auxiliary power source
PCB assembly
CN44
YC1
YC1
1-2-5