Kyocera Mita KM-2530 Service Manual page 40

5. Remove the screw and then the cover from
the rear of the paper feed desk.
6. Remove the screw from the copier.
7. Insert the 12-P connector of the paper
feed desk into the connector on the copier.
8. Route the harness through the clamp on the
retainer.
9. Fit the retainer using the screw removed in
step 6 and the two CVM4 × 06 cross-head
chromate binding screws.
10. Refit the cover.
Screw
Screw
Figure 1-3-21
12-P connector
Figure 1-3-22
Clamp
Harness
Figure 1-3-23
2DF
Cover
Retainer
Screw
CVM4 × 06 cross-head
chromate binding screws
1-3-19