Kyocera Mita KM-2530 Service Manual page 599

4. Move the shielding cover out of the way to the left, and fasten the
fax control PCB into place using four M3 × 06 chrome binding
screws.
5. Connect the NCU cable to connector CN1 on the NCU board
assembly.
6. Fasten the NCU board assembly into place from the bottom with
two M3 × 06 chrome binding screws.
7. Connect the three connectors from the NCU board assembly to the
corresponding connectors on the fax control PCB, as follows:
• Speaker 2-pin connector → YC7
• NCU cable connector → YC3
• Battery connector → YC6
Fax control PCB
Shielding cover
Figure 1-2-5
CN1
NCU board assembly
Figure 1-2-6
NCU board assembly
Figure 1-2-7
3DB
M3 × 06 chrome
binding screws
NCU cable
M3 × 06 chrome
binding screws
1-2-3