Kyocera Mita KM-2530 Service Manual page 115

Maintenance
item No.
U113 Performing drum refresh operation
Description
Executes drum refresh operation.
Purpose
To operate when image flow occurs.
Method
1. Press the start key. The screen for executing is displayed.
2. Press the start key. Drum refresh operation starts. (approximately 3 minutes)
3. To stop the operation, press the stop/clear key.
Completion
Press the stop/clear key when the operation stops. The screen for selecting a maintenance item No. is
displayed.
U130 Initial setting for the developer
Description
Replenishes toner to the developer unit to a certain level from the toner container that has been installed.
Purpose
To operate when installing the machine or replacing the developing unit.
Method
1. Press the start key. The screen for executing is displayed.
2. Press the start key. The time that elapses until initialization is complete and whether or not toner remains in
the developing unit (0: No, 1: Yes) are displayed.
Supplement
The following data is also renewed or cleared by performing this maintenance item:
• Clearing the developing drive time (U157)
• Clearing the developing count (U158)
• Resetting the toner feed start level and toner empty detection
Completion
Press the stop/clear key after initial setting is complete. The screen for selecting a maintenance item No. is
displayed.
U144 Setting toner loading operation
Description
Sets toner loading operation after completion of copying.
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item. The selected item is displayed im reverse.
Display
MODE0
MODE1
MODE2
Initial setting: MODE2
3. Press the start key. The value is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Toner not loaded
Toner not loaded
Toner loaded
2DF
1-4-27