Kyocera Mita KM-2530 Service Manual page 76

12. Remove a screw, turn the metal fittings
upward, and fit the screw again to the lower
hole.
13. Insert the intermediate tray and connect the
connector (white) of the intermediate tray to
the transfer unit. Connect the connectors
(gray) to the connectors of the copier as
shown in the illustration.
Connect the gray connector with more pins to
the upper connector and the gray connector
with less pins to the lower connector.
14. Attach the intermediate tray to the copier as
shown in the illustration so that the right and
left pins of the intermediate tray are
positioned to the recessed portions of the
copier and the transfer unit.
Recessed portion
Transfer unit
Metal fittings
Screw
Screw
Figure 1-3-113
Connector (white)
Intermediate tray
Figure 1-3-114
Figure 1-3-115
2DF
Connector (gray)
Pin
Recessed porton
Intermediate tray
1-3-53