Kyocera Mita KM-2530 Service Manual page 43

2DF
5. Remove the screw and then the cover from
the rear of the large paper deck.
6. Remove the screw from the rear of the copier.
7. Insert the 12-pin connector of the large paper
deck into the connector on the copier.
8. Fit the retainer using the screw removed in
step 6 and the two CVM4 × 06 cross-head
chromate binding screws.
9. Refit the cover using the screw (see step 5).
1-3-22
Screw
Figure 1-3-29
Figure 1-3-30
CVM4 × 06 cross-head
chromate binding screw
Screw
Figure 1-3-31
Screw
Cover
12-pin connector
Retainer
CVM4 × 06 cross-head
chromate binding screw