Kyocera Mita KM-2530 Service Manual page 642

3DB
Maintenance
item No.
U881 Writing data from the flash-memory jig into SRAM
(cont.) Writes the data from the jig into the machine's SRAM.
DOWNLOAD FROM JIG?
1. Press the start key. The data write is executed, and the screen displays the result.
• If the write operation was successful:
DOWNLOAD FROM JIG
OK
• If the write operation failed:
DOWNLOAD FROM JIG
NG XXX
2. Press the stop/clear key.
3. Turn the power off.
Writing the boot program into the jig
Writes the boot program into the flash memory in the jig.
1. When this item is pressed, the machine writes the boot program into the jig's flash memory, and the screen
displays the result.
• If the write operation was successful:
WRITE PROGRAM
OK
• If the write operation failed:
WRITE PROGRAM
NG XXX
2. Press the stop/clear key.
3. Turn the power off.
1-3-34
Description
where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U881" on page 1-3-36.
where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U881" on page 1-3-36.