Parts Names And Their Functions; Main Body - Kyocera Mita KM-2530 Service Manual

3DB

1-1-2 Parts names and their functions

(1) Main body

1 Operation panel ..................................... Use the operation panel to perform the procedures required for fax
2 Fax storage section ................................ Received documents are ejected and stored face-down in the fax storage
3 Drawers .................................................. This fax machine comes standard with two drawers installed. Each drawer
4 Multi-Bypass .......................................... Paper can be set in the Multi-Bypass as well. In order to use the Multi-
5 Telephone jack (T) .................................. Use this jack to connect a separately purchased telephone to the fax.
6 Line jack (L) ........................................... Use this jack to connect the fax to a telephone line using the modular cord.
7 Main switch ............................................ Turn this switch ON ( | ) in order to perform fax and copy operations. The
• Document Processor
There are 2 optional document processors available for use with this machine: the document processors for feeding one-
sided documents, and the duplex document processor for using both sides of 2-sided documents.
* Both the document processor and duplex document processor can be used with the 25 copies per minute machine.
However, only the duplex document processor can be used with the 35/40 copies per minute machine.
8 Document table ...................................... Set the documents to transmit on the table. Up to 100 sheets of up to 11" × 8
9 Document insert guides ......................... Adjust these guides to match the width of the documents.
10 Document processor reversing cover ..... Open this cover if a document jams.
11 Document eject cover ............................ Documents are ejected onto this cover after being scanned.
12 Eject guide ............................................. Open this guide when transmitting documents of a large size such as 8
13 Document processor open/close lever ... Operate this lever when opening and closing the document processor.
14 Document set indicator .......................... This indicator indicates the status of the documents set in the document
1-1-4
Figure 1-1-1
communication.
section. Up to 250 sheets can be stored in this section at one time.
can hold up to 500 sheets of plain paper (60 g/m
Bypass, it is necessary to select "ON" under "Turning Manual Paper Feed
ON/OFF".
message display will light and operation will be possible.
1
/ " [A4] size paper, or up to 70 sheets of 8
2
Folio] size paper, can be set at one time when installing the duplex document
processor. Up to 70 sheets of up to 11" × 8
sheets of 8
time when installing the document processor.
×14" or 11" × 17" [A3 or Folio].
processor. Documents are set properly when the indicator is lit green.
" × 14" or 11" × 17" [A3 or Folio] size paper, can be set at one
1
/
2
Figure 1-1-2
2 2
- 105 g/m ).
" × 14" or 11" × 17" [A3 or
1
/
2
1
/ " [A4] size paper, or up to 50
2
1
/ "
2